Sea-Doo Spark 2014 Onwards Service Workshop Manual

Workshop Service & Repair Manual for Sea-Doo Spark 2014 onwards a must-have for any Sea-Doo Spark owner. Covering every service and repair procedure in full Sea-Doo factory specification with full step by step instructions on carrying out work in the correct sequence. Please note that this manual does NOT cover models fitted with IBR but as with all our top quality manuals, this has every other item covered over the sections below.

Sea-Doo Spark 2014 Onwards: 200+ Pages

This Manual Covers The Following Items:

Air intake system

Body

Charging system

Communication Tools and BUDS

Connector Information

Controller Area Network (CAN)

Cooling System

Cylinder Block

Cylinder Head

Diagnostic and Fault Codes

Drive Shaft

Electronic Fuel Injection EFI

Engine Management System

Engine removal and installation

Error codes 2014 Sea-Doo SPARK DTC Table

Exhaust System

Fuel Tank and Fuel Pump

Hull

iControl System

Ignition system

Intelligent Throttle Control (iTC)

Jet Pump

Lubrication System

Magneto and Starter

Multifunction Gauge

Operators Guide Spark

Periodic Maintenance Procedures

Periodic Maintenance Schedule

Power Distribution and Grounds

Preseason Preparation

Spark Hull Repair

Spark Spec

Spark Special Tools

Special procedures

Starting System

Steering and OTAS Systems

Storage procedure

Technical specifications

Timing Chain

Wiring Diagram – DIA-14-4T-903-2013-04-23

Wiring Diagram – DIA-14-4TSI-903-2013-04-23

Wiring Diagram Information